It's very simple. You need to use in Report field a Output Variable the next type:
Cap=(-1/(2*pi*freq*im(Z(1,1))))*10^12.
For this Variable you can make a plot or a table.
The result's unit will in pF.
Good luck!
It's very simple. You need to use in Report field a Output Variable the next type:
Cap=(-1/(2*pi*freq*im(Z(1,1))))*10^12.
For this Variable you can make a plot or a table.
The result's unit will in pF.
Good luck!
It's very simple. You need to use in Report field a Output Variable the next type:
Cap=(-1/(2*pi*freq*im(Z(1,1))))*10^12.
For this Variable you can make a plot or a table.
The result's unit will in pF.
Good luck!
The formula is right. I checked simulation's results with numerical for different models and all was OK. I think: You've a model's mistake. Check boundarys, ports and use manual meshing. Also look at the Report's field. May be, you use wrong output conditions.