redcrystalline
Advanced Member level 4
Hi
i have trouble with anisotropic material assignment based on Solid coordinate system using CST Microwave Studio.
When i open new material dialog, in General tab there is not any option to change coordinate system. i have done everything but it always show xyz coordinate. how can i overcome this problem. any comment and suggestion with CST Software is welcomed.
Wish all the best.
i have trouble with anisotropic material assignment based on Solid coordinate system using CST Microwave Studio.
When i open new material dialog, in General tab there is not any option to change coordinate system. i have done everything but it always show xyz coordinate. how can i overcome this problem. any comment and suggestion with CST Software is welcomed.
Wish all the best.