Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HFSS S21 greater than 1?

Status
Not open for further replies.
R

Roro28

Newbie level 6
Newbie level 6
Joined
Jun 26, 2012
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,357
Hello,

I have a 2 port model in HFSS with 50 ohms lumped ports. Basically there are 2 coils coupled together at a frequency near 10 MHz. I got an S21 value of slightly greater than 1 at the resonant frequency. Does anybody know why this happened?
 

HFSS uses the Finite Element Method in the Frequency Domain that is a numerical method. using the numerical methods need to mesh the objects nice and having knowledge about the kernel of the method. So if you have S21 greater then 1 means that you can not execute the HFSS good. you should change the setting and run it again to correct the file.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top