Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Set up your stripline port like you would set up a coaxial (wave) port. Then look at the port fields display to make sure that it is operating correctly. There are trades between wave and lumped ports. Both have their place and both have disadvantages. I gravitate to wave ports.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.