HFSS-mesh problem on waveport

Status
Not open for further replies.
J

jslee

Junior Member level 1
Joined
Nov 19, 2005
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,488
Hi,
I do a simulation about microstrip line based one the driven terminal soultion type.I set up two waveport one the two ends of the ustrip.But I find that the mesh is diffrent from the two sides.This causes the S11 or Zo is different at two port.This obviously is incorrect.May I make some adjustment to let the mesh symmerty?

Thanks for your help
Sincerely, Jslee
 

There is no way to make mesh symmetrical, but you can refine it in both ports.
So, if ports are equal, the difference will be negligible finally
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…