HFSS complex impedance port setting

Status
Not open for further replies.
S

shanmei

Advanced Member level 1
Joined
Jul 26, 2006
Messages
430
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,298
Location
USA
Activity points
4,496
I don't know how to set the port impedance to be complex value for simulation of RFID tag antenna?

I want to use RFID chip which has the impedance of 12-j140. For the conjugate matching, I need to set the port impedance 12+j140.

However, the port impedance setting of HFSS only allows me to choose 50 ohms, not the complex value of 12+j140.

From the HFSS-Excitations-Assign_lumped port, I can only choose 50 ohms. How can I choose 12+j140? Thanks.
 

HFSS will compute the frequency response of the structure with 50 Ohm Zo first then if you wish, it will compute in according with your terminal impedance.
 
Go to HFSS/design settings/S parameter definition - choose "power".
You can also specify complex impedance defining the impedance as: 12 +1i*140. this should work (from 18.1 I think)
 

Attachments

  • Capture.PNG
    15.3 KB · Views: 405
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…