Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm using QT101 ic to make my sensor, the sensitivity is not that strong if i add a arylic below the copper, but it doesn't work well, when touch the panel.
I have no idea what chip that is, but for a touch sensor board you need stable plastic caps and not ceramic FYI. Consider polyamid insulator smallest thickness .. goes by Kapton brand in tape instead of acrylic
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
