Hello Alfred,
Okay, You are using S-parameter data file (NE85635A.S2P) which is already
Biased ate VCE=10V, IC=7mA & which is a linear model...
Hence you should not bias once again, but for the layout you can lay down the Bias network.
if you have nonlinear model (Spice file) for this device then your bias setup is correct in MWO...
What you can do here is just remove the Bias network, only place the matching circuit
& then do the s-parameter simulation you may get the desired gain if not optimize ...
Also note that you need to remove the V & I meters as this is a Linear simulation only & you cannot see
the node / element voltages /currents (only possible to see in DC/Nonlinear simulation)...
Once you have nonlinear model you can do this simulation...
Also I observed that this model looks like obsolete on CEL website, see attached picture...
---manju---