Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

help needed:multi-FLEX6000 configuration(PS mode) with a MCU

Status
Not open for further replies.
C

cdcll

Full Member level 3
Full Member level 3
Joined
Feb 15, 2002
Messages
163
Helped
8
Reputation
16
Reaction score
1
Trophy points
1,298
Activity points
1,199
Hello everyone,

I need to do 2 @ltare FLEX6000 devices configuration using one MCU, according to the doc from @ltera, I have to design a device chain, and the nCEO pin of the first device should be connected to the nCE pin of the next one, and the nCEO pin should be left unconnected for the last device in the chain, but I can not find the nCEO pin for the FLEX6016A chip, can anybody tell me which pin is the nCEO pin? or I have to use a general I/O pin as nCEO?

Best Regards,
cdcll
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top