collinjie,
You are right. The MAX41490 is a video amplifier, not suitable for your application.
~
I would suggest using any Op-Amp that has a low input offset voltage spec, such as the Analog Devices AD8677.
~
If you need a non inverting amplifier, connect a feedback resistor RF from the output to the inverting input. Connect an input resistor Ri from the inverting input to ground. Use the non-inverting input to the OP-Amp as your amplifier input. The feedback resistor must be 0.775 X the input resistor.
~
For an inverting amplifier, connect the feedback resistor Rf from the Op-Amp output to the inverting input. Connect the input resistor Ri to the inverting input of the Op-Amp. The other end of the input resistor is your amplifier input. The feedback resistor must be 1.775 X the input resistor.
~
An instrumentation Amplifier, such as the Analog Devices AD8230 would also work, but it would be a more expensive solution. Most IAs have the capability of setting the gain with a single resistor. Again, you would have to use series or parallel combinations of resistors to get the correct resistor value
~
You won't be able to find standard resistor values that meet your resistor value requirements. You will have to use series or parallel combinations of resistors to get the correct value for either Rf or Ri, or the gain setting resistor, if you decide to use an IA. In addition, the resistor tolerances must be on the order of 0.5% to meet your accuracy requirements.
Regards,
Kral