Help me solve a problem with Genius universal programmer

[abbas1707]

hi,
im facing a bigggggggggggg problem.
im using chinese universal programmer named Genius programmer.
i have just used it for 10 days .and now it is showing problem.

>>when i press erase button its ok.
>>whem i press read its ok.
>>but when i load my hex file and press program button then it shows a warning
" program error ".
i cant understand where the problem is. i have replaced 3 microcontrollers. but the problem is same.this problem was not occurring two days before.
plzzz plzzz help me out...
i will be very thankful to u!!!
plz help me....plzzz

 

[amrstaha]

Re: can any1 help me????

I think I faced a similar problem sometime ago with a programmer. Try to restart your PC and the programmer. Also use a shielded cable (especially for parallel type interfaces), cheap cables are not shielded.

 

[solidsnike]

Re: can any1 help me????

hi man
i got this problm too .....
try to fix or make sure of your LPT or if you are using COM cable and its wires >>
and good luck

 

[Computerman29]

Re: can any1 help me????

Greetings,
Use the shortest cable possible. Also, make sure the port (COM, LPT) is properly configured in both the software and the hardware.

 

[vjfaisal]

Re: can any1 help me????

yes, that is the great idea of using Use the shortest cable possible.