Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the single line diagram of three phase power system is shown below ,the transformer capacity is 100MVAR and the rectance =20% on abase of 100MVAR ,23/115KV and the impedance Z=100j,the load at bus 2 is S2=184.8MW+6.6jMVAR ,and the bus 3 is S3=0MW+20jMVAR . it is required to hold the voltage at bus 3at 115KV.working in per unit ,determine the voltage at bus 2 and bus 1
THIS IS THE QUESTION AND THE DIAGRAM IN THE ATTACHMENT
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.