srikanth977
Newbie level 5
Hi all,
This time I am stuck with the PCB for PIC24FJ64GA004.
I have to build a basic board (Crystal oscillator,MCLR circuit, capacitors as per datasheet, and Programming pins)
I am leaving few pins to a connector so that i can connect PICKIT3 and program the controller.
My doubt is regarding the programming pins for controller.
I am using the MCLR, PGED1(Pin21) & PGEC1(Pin22) respectively for programming.
Is this enough or i should also use EMUDx pins?
Please confirm.
This time I am stuck with the PCB for PIC24FJ64GA004.
I have to build a basic board (Crystal oscillator,MCLR circuit, capacitors as per datasheet, and Programming pins)
I am leaving few pins to a connector so that i can connect PICKIT3 and program the controller.
My doubt is regarding the programming pins for controller.
I am using the MCLR, PGED1(Pin21) & PGEC1(Pin22) respectively for programming.
Is this enough or i should also use EMUDx pins?
Please confirm.