Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help me about Brenner8

Status
Not open for further replies.

fino

Newbie level 3
Newbie level 3
Joined
Aug 8, 2008
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,302
brenner8

Anybody knows what'wrong with the progammer ? Is Pic 16F877A damaged? Thanks!
 

vista driver for pic brenner8

Do you program other pics with this brenner???

Are use brenner in windows vista?? Already exists driver for vista??
But if you dont program other pics, i think you must calibrate the vpp.
 

brenner8 problem

fino said:
Anybody knows what'wrong with the progammer ? Is Pic 16F877A damaged? Thanks!

I think it is due to the PIC. In the interface I see the pic cathegory is 16fxxx however the cathegory of pic that you use is 16fxxxA.
 

brenner8 -sprut

check the programming votage.
 

pic brenner8 picture problems

Eraser said:
Do you program other pics with this brenner???

Are use brenner in windows vista?? Already exists driver for vista??
But if you dont program other pics, i think you must calibrate the vpp.

I use WinXp .How to calibrate ? What 's Vpp ? I'm a newbie ,can you explain it. I just push into "auto_adjust offset and gain" in calibration/test .After that ,there is only 1 value in Vpp (m) for 10V ,11V,12V ,13V ,can't adjust by U-divider >.<
@AdvaRes : this is the image ,programming a PIC 16F877A successfully
 

brenner8 driver

the vpp is the programming voltage for pic, the "auto_adjust offset and gain" is what i am talking about.
Do you replace the pic for other equal??
By the way if you cilck in detect pic in programmer the pic is detected???
if the pic is detected check the 10uH coil, check the Vcc after and before the coil, they must be equal.
I had the same problem, and was the coil.
 

checking 16f877a damaged

Thanks all,I have found my problem .My programmer didn't back up the calibration ,so every I use it ,I must calibrate again.:|
 

brenner8 english

hi i am progamming pic16f877a by brenner8.i select the hex file and load to the pic without any problem and i can see the memory map is full not empty.but when i close
useburn.exe and open it again the memeory map seems empty.i think this means
the pic is empty.the hex file has not been loaded.how can i load the hex file properly.
whot can the problem be? thak u for your help
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top