Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help in GSM Shield

Status
Not open for further replies.
Turning ON/OFF only the supply of the SIM card should automatically register to the network. Have to check if this is possible to do in the software of the module.

Also there should be AT commands that allow to register without power ON/OFF:

**broken link removed**
 
  • Like
Reactions: brian25

    brian25

    brian25

    Points: 2
    Helpful Answer Positive Rating
the Gsm will automatic On the status and net light pin when connected to arduino without using codes to On it automatically in the program
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top