[Help]Getting Started Protocols for USB, SPI, CAN and Ethernet

[jjeevan007]

hi to all,

i want learn the USB, Ethernet, SPI and CAN on my own, so please help with getting started.

please suggest any good books or Videos on USB and Ethernet please its urgent.



regards
jeevan

 

[HMS1021]

I believe to fully understand each of these standards you will need to have "hands on" experience with both the hardware and software. There are many "stick" processors (SiLabs, Ti, etc.) under $40 today with these interfaces. A low cost logic analyzer or at least a oscilloscope is useful for SPI, I2C and CAN and protocol analyzers for USB and Ethernet. I2C is another common interface to add to your list.

SPI, CAN and I2C are such simple interfaces that several hours web browsing should give you what you need. Example; see https://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus for SPI.
For USB I like the books written by Don Anderson and published by MindShare, Inc. via Amazon.
I do not have a favorite for Ethernet.

 

[tpetar]

Start searching existing EDABoard threads, you will find lots of materials and links for this.

 

[josiphal]

For USB good one is http://www.beyondlogic.org/usbnutshell/usb1.shtml and every micro brand have own (open source) USB Stack, with examples.

Also http://retired.beyondlogic.org is good source for other protocols.

 

[jjeevan007]

i want implement the communication between the pc and lpc2148 please some me.........


share if u have any code and corresponding software


regards
jeevan

 

[jjeevan007]

please share some code.


regards
jeevan