lunren
Member level 4
waveform type must be
I use Cadence to work on a project, but there is a error: V5: Waveform type must be specified if any waveform parameters are given.
I searched internet, it seems that lot of people meeting this problem, but no good solutions. Anybody here can give some ideas?
Another problem is that dependent sources from analogLib can not be used. For example, when I set the gain of vcvs to 2 and extract netlist, the gain parameter can not be extracted. The netlist is always like this:
E1 (net1 net2 net3 net4) vcvs
The gain=2 parameter is always ignored. How to deal this problem?
Added after 2 minutes:
By the way, I installed IC5141 USR4
I use Cadence to work on a project, but there is a error: V5: Waveform type must be specified if any waveform parameters are given.
I searched internet, it seems that lot of people meeting this problem, but no good solutions. Anybody here can give some ideas?
Another problem is that dependent sources from analogLib can not be used. For example, when I set the gain of vcvs to 2 and extract netlist, the gain parameter can not be extracted. The netlist is always like this:
E1 (net1 net2 net3 net4) vcvs
The gain=2 parameter is always ignored. How to deal this problem?
Added after 2 minutes:
By the way, I installed IC5141 USR4