Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HCTL-2032, only 16 or 24bit counter

Status
Not open for further replies.
Q

qaysw123

Newbie level 1
Joined
Dec 25, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
Hello, I have a problem with Quadrature Decoder/Counter HCTL-2032. When I read the value from the counter I only get 16 or 24 bit value so after 65535 or 16 777 215 pulses it starts to count from 0. It depends on the count mode, when I change EN1 and EN2 to 4x mode I get 16bit otherwise in 1x or 2x mode I get 24bit. Never 32bit. I can see in the datasheet that it supports 8, 16, 24, or 32-Bit Operating Modes and on the page 14 there are some possibilities A,B,C,D. But I don´t understand how to use or change it. Does anybode have any experience?

Thank you in advance for your help

Added after 4 hours 32 minutes:

The problem was caused by wrong joining of bytes
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top