hc908 code warrior programming
To my knowledge this programmers can be used only on the HCS08 family of devices. I really do not know if it can be used on HC08 devices, because I have never used them...
Are you sure you need to work with the HC08 family?
BTW, the BDM is a programmer AND a debugger.
It require you to use only 4 wires: GND, Vcc, BDM pin and Reset.
The great plus of this interface is that you can plug-in the debugger connector on a running micro and you can take a look to the internal micro state (ram, registers, ..)
without stopping it!
After using this feature, one of my priority requirement during the choice of a micro is a debugging interface
à la BDM.
As I previously wrote, using
Processor Expert is another bonus in speeding the developement for those micros.
Another plus (if you are using the JM or QE families) is you can migrate to the same pinout chip but with an internal 32 bit core (with the same peripherials): it can really speed up the execution of your code, especially if your customer asks for more computations/code size.
P.S.: Just take a look to the attached document...