Vijay Vinay
Member level 5
Hello all,
I have drawn the layout for my inductor design. When I try to run ADS Momentum, it returns with a error message "The following exception was raised during geometry processing: basic_ios::clear" and doesn't perform the S-parameter calculations( in my case). I am not sure why there is such an error being displayed every time I change the layout design and try out Momentum simulation. An immediate reply in return would be helpful. Thanks in advance.
Attached you would see the layout design of my inductor
I have drawn the layout for my inductor design. When I try to run ADS Momentum, it returns with a error message "The following exception was raised during geometry processing: basic_ios::clear" and doesn't perform the S-parameter calculations( in my case). I am not sure why there is such an error being displayed every time I change the layout design and try out Momentum simulation. An immediate reply in return would be helpful. Thanks in advance.
Attached you would see the layout design of my inductor