Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You could use a high speed comparator, such as one of these, operating from ±5V supplies. Bias the negative input to about +1.5V. Feed the TTL signal to the positive input.
You may need to add some hysteresis to the positive input to avoid oscillations during the waveform transition.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.