AlexisB
Junior Member level 1
Hi,
I have a problem with the FT2232H programming trying to use the FIFO Mode.
I have a Morph-IC-II and I'm using D2XX drivers to speak with the FT2232H on board.
I manage to have the 60Mhz clock input (which is my main fpga clock) and I can transfer data from the PC to my FPGA with FT_Write(). The RXF# signal works fine (SignalTap used to check signals).
My main problem is : I can't find how to put the TXE# pin low and therefore be able to send data from my fpga to the pc.
I have no idea what I did wrong or what i forgot to make the ft2232h ready to receive data.
Thank you for your help.
Alexis
I have a problem with the FT2232H programming trying to use the FIFO Mode.
I have a Morph-IC-II and I'm using D2XX drivers to speak with the FT2232H on board.
I manage to have the 60Mhz clock input (which is my main fpga clock) and I can transfer data from the PC to my FPGA with FT_Write(). The RXF# signal works fine (SignalTap used to check signals).
My main problem is : I can't find how to put the TXE# pin low and therefore be able to send data from my fpga to the pc.
I have no idea what I did wrong or what i forgot to make the ft2232h ready to receive data.
Thank you for your help.
Alexis