Hi,
I am new to ADS layout simulation. I have simulated the folded dipole microstrip antenna suggested by TI(Texas Instruments) for transreceiver chip CC2500 to work for 2.4GHz frequency in ADS (whose datasheet is attached) but I am not getting the desired output.
I have attached the method that I followed with the datasheets required.
So please suggest me if I am following the wrong method of simulation or there is some other error.
Please help me out.
I changed the settings as you have told but the results is not the required one.One thing I haven't understood is that if we make the ground plane open then how to make the epsilon value one. Do I have to change the epsilon value of dielectric layer? I tried that too but the results were same as previously I attached.
I have attached the change of the setting images and also the differential port setting that you wanted to observe. Please let me know about any changes to be made or if any conclusion is made about the settings.