Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

fixing the X & Y location of NC drills in the Expedition

Status
Not open for further replies.

arunrajendhar

Member level 3
Joined
Dec 25, 2008
Messages
63
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
India
Activity points
1,623
Hi ALL,

When i ran the nc drill in expedition pcb its get move to its original location were it located in the pcb but i want to move that in the locations I want, so please help me to fix the nc drill location. (Change the nc drill location)

Also please tell me that How the nc drills get generated for the Blind vias (Sequential lamination boards)

thanks,
[/img]
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top