Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

First time programming an ARM MCU with a J-link, where do I start?

Status
Not open for further replies.
P

Plecto

Full Member level 5
Full Member level 5
Joined
Jan 4, 2012
Messages
315
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Visit site
Activity points
4,979
I want to program my LPC1114 by using my Segger J-link ARM, but my only previous experience is with an Arduino so I have no idea of where to start. After installing the software and the driver for my J-link, about 16 .exe files were avaible, most of them giving me some command prompt. Scrolling through the 322 page manual for my J-link didn't help much, I'm pretty much lost as to how I'm supposed to do this. Can anyone please point me in the right direction?
 

HI

May be help but I am not practices this

LPC1114C.JPG
circuitLPC1114.jpg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top