halee awan
Full Member level 3
A basic Q:
I've two Coils(air core) that have only 3 turns of copper wire 27AWG.
I'll use them later in my cct
but first i wanna perform a basic test on it
I want to see the flux liinkage or induction effect of one coil to other one at different frequencies .
But i am scared that if i connect it directly to the F.Genrator's output it might damage the F.Generator .due to very low R (Short cct )and impedance mismatching etc ...
If i introduce A known value of R in series what will happen
Wheather it wil effect the actual theam (induced emf)or not?
or what should i do any usefull suggession will be highly appericiated
I've two Coils(air core) that have only 3 turns of copper wire 27AWG.
I'll use them later in my cct
but first i wanna perform a basic test on it
I want to see the flux liinkage or induction effect of one coil to other one at different frequencies .
But i am scared that if i connect it directly to the F.Genrator's output it might damage the F.Generator .due to very low R (Short cct )and impedance mismatching etc ...
If i introduce A known value of R in series what will happen
Wheather it wil effect the actual theam (induced emf)or not?
or what should i do any usefull suggession will be highly appericiated