FEKO - Mesh dependent on the frequency

[ayasha]

Hi!

I am new to FEKO and since I have to simulate a very big geometry I would like to use MoM and to have a mesh that is frequency dependent, but I don't know how to do it with FEKO. What should I write in the Triangle edge length?I have set the frequency "Linearly spaced discrete points" and I don't know how to refere to those frequencies!

Thanks a lot!

 

[chameleon]

FEKO has the option to suggest a mesh size depending on your frequency. If your problem electrically large (i.e. compared to wavelength, or in other words in terms of wavelength) then you may split your frequency ranges into smaller pieces, 2:1 or 3:1 bandwidth ratios. So that you don't have to use unnecessarily dense mesh even for smallest frequency.