int19
Newbie level 6
Hi all!
I try to explain wich is my problem.
I have a register file in wich writing a register is done on falling edge, but in the other modules of the DSP each operation occurs on rising edge.
When Encounter performs timing analysis it results a skew of about half cycle just on the register file. Is there any way to tell encounter to not consider this skew as negative?
I hope have been clear,
regards.
I try to explain wich is my problem.
I have a register file in wich writing a register is done on falling edge, but in the other modules of the DSP each operation occurs on rising edge.
When Encounter performs timing analysis it results a skew of about half cycle just on the register file. Is there any way to tell encounter to not consider this skew as negative?
I hope have been clear,
regards.