Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

External Pullup on CPLD

Status
Not open for further replies.
S

soumen21

Member level 5
Joined
May 7, 2011
Messages
81
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Activity points
1,801
Hi, I have a cpld XC9536XL (3.3V operated). One pin is configured as output. Before loading the code configuring the pin as output, a 1K pull up resistor is used and the resistor is tied to 5V. Will it damage the CPLD due to backdriving i.e. from 5V to 3.3V ?
 

soumen21 said:
Hi, I have a cpld XC9536XL (3.3V operated). One pin is configured as output. Before loading the code configuring the pin as output, a 1K pull up resistor is used and the resistor is tied to 5V. Will it damage the CPLD due to backdriving i.e. from 5V to 3.3V ?
Click to expand...

The I/O pins of this chip are 5V tolerant so it should be fine.
 
Last edited:

Can I configure this pin as 'inout' and can have a pullup resistor to 5V ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top