Exporting gerber file from cst microwave studio

Status
Not open for further replies.
P

pixiemouse

Newbie level 4
Joined
Nov 8, 2009
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,317
Hi,

I am new to CST as well as PCB milling. I tried exporting a antenna simulation from CST as a gerber file. ISOPRO does not register the aperture list for some reason. All it shows is D999 with 0 width.

I also tried to view the gerber file using McCAD. Again McCAD shows an empty aperture table. Any ideas why this is happening.


Really appreciate your help.

Thanks
 

i'm not sure. try manual create aperture.
 

Hi all, greetings to all,

I'm currently designing a 180 degree compact rat-race hybrid coupler for butler matrix network. I divided my rat-race into 8 sub-structures : 4 t-junctions, 2 bends and 2 straight lines. I've already obtained the results for each part of my sub-structure. But now i'm not sure how to combine the structures so that i can obtain the output for the whole rat-race hybrid coupler that is 180 degree phase difference. I'm aware of exporting the sub-structures to DXF file format but i am not sure which environment or how is the step to combine it and get the combined rat-race hybrid coupler output.

Appreciate very much if you can help. Thanks

Best & Warmest Regards,
SAM
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…