Feb 24, 2015 #1 V vaibhavpawar Junior Member level 1 Joined Nov 9, 2014 Messages 19 Helped 0 Reputation 0 Reaction score 0 Trophy points 1 Activity points 178 If LPC2138 is 3.3V supported where as ATmega88 is 5V supported. Can we establish communication between them using I2C protocol. If yes, then pull up should be tied to 5V or 3.3V? Is there any other special precaution should be considered in this case? Thank you in advance.
If LPC2138 is 3.3V supported where as ATmega88 is 5V supported. Can we establish communication between them using I2C protocol. If yes, then pull up should be tied to 5V or 3.3V? Is there any other special precaution should be considered in this case? Thank you in advance.
Feb 24, 2015 #2 Surendhar M Banned Joined Jan 10, 2013 Messages 110 Helped 15 Reputation 200 Reaction score 100 Trophy points 1,323 Location Chennai Activity points 0 Need to check VIH and VOH of both the IC's if it is in acceptable range you can. When considering about I2C you need to connect the pull-up resistor to supply of the slave device.
Need to check VIH and VOH of both the IC's if it is in acceptable range you can. When considering about I2C you need to connect the pull-up resistor to supply of the slave device.