Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

error in current source excitation using feko

Status
Not open for further replies.

yattharth

Junior Member level 1
Joined
Sep 13, 2013
Messages
17
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
109
hi folks,,,, i am using feko 5.5
i am trying to excite a line(dipole antenna) using current source. i have used FEM line port giving its coordinate values that are present on the line. but i am receiving the following error:The line current source must be inside a FEM region....
any help
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top