Error in create net list

[saro18]

Hi to all,
I created one schematic in OrCAD capture CIS , the result of "Design rules check" was zero, but in netlist creation i affected some error ,

Error: " Multiple pin 14's which have different nets connected for U7"..

(U7 is a 3 part Heterogeneous components , so the 14th pin VDD and 7th pin GND so it repeated in each part,
if i delete that pin otherwise show the "duplicate pin U7 pin 14" )

please give some suggestion for to complete that schematic .
Regards,
NagaSaravanan

 

[barry]

Not sure, but if it's a HETEROGENEOUS part, pins 14 and 7 should only show on one of the three parts, right? As far as the netlister is concerned, there's no distinction be VCC, ground or any other pin.