sandruska
Junior Member level 3
I'm trying to analize a coaxial to circular waveguide transitions and when I try to do a fast sweep, HFSS shows the next message:
[error] Fast sweep setup, process abc3d : "LumpPort1" mode 1 crosses cut-off in the specified fast sweep range. Consider splitting the sweep into multiple ranges. Use a port-only discrete sweep to locate the cut-off frequency.
What does this mean?
Thanks and Regards.
[error] Fast sweep setup, process abc3d : "LumpPort1" mode 1 crosses cut-off in the specified fast sweep range. Consider splitting the sweep into multiple ranges. Use a port-only discrete sweep to locate the cut-off frequency.
What does this mean?
Thanks and Regards.