Error during hardware software co-simulation using ZCU102 board

Status
Not open for further replies.
A

ankit rajput

Newbie level 6
Joined
Apr 9, 2011
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,386
Hi

I am trying to do hardware software co-simulation using ZCU 102 zynq ultrascale board. I am able to generate hardware software co-sim block as shown below:

**broken link removed**


but when I add add this block to simulink and try to run i get the following error:

**broken link removed**




I find out that part number of zcu102 board shown in system generator token and hwcosim block has a difference of one alphabet , shown in below images:

**broken link removed**

**broken link removed**

Is this a reason for error?
how to solve that?

thanks
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…