Hi all,
I am attempting to import a gds file from encounter to virtusoo.
There is only one problem that some of ports are not recognized in virtuso when doing LVS.
When I digged into the layout and I discovered that the routing layer to encounter to the pin layer for some pins are too short.
recognized ports:
Unrecognized ports:
I have been tryng to figure out if I can control this ovelap lenght however it is been unsucsessful. I relly appreciate your help on this.
I did not exactly solve the problem in encounter. However, I solved the problem and made the layout LVS clea,n by writing a script which replaces the pin layer to drawing layer in virtuso.
I hope it helps for some of you having the same problem.