Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] encounter_virtuoso_port_mismatch

Status
Not open for further replies.

parsatt

Junior Member level 2
Junior Member level 2
Joined
Jan 6, 2010
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,450
Hi all,
I am attempting to import a gds file from encounter to virtusoo.
There is only one problem that some of ports are not recognized in virtuso when doing LVS.
When I digged into the layout and I discovered that the routing layer to encounter to the pin layer for some pins are too short.
recognized ports:
rec.jpg
Unrecognized ports:
unrec.jpg

I have been tryng to figure out if I can control this ovelap lenght however it is been unsucsessful. I relly appreciate your help on this.
 

I did not exactly solve the problem in encounter. However, I solved the problem and made the layout LVS clea,n by writing a script which replaces the pin layer to drawing layer in virtuso.
I hope it helps for some of you having the same problem.

--Parsatt
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top