Eagle - Ripup but connected

[janfred]

Hi guys,

i've a problem...
Eagle still shows me an airline(ripup-line) although it's connected by the GND-Layer and the Pads.



I did Ratsnest a couple of times, I tried a new GND-Polygon and I also checked the Schematics.. everything fine..

- How can I solve that?
- And by the way... are there options to increase the Isolation for the Ground-Pins?

 

[Kick]

ur ground plane might be broken.

 

[janfred]

ur ground plane might be broken.

haha :idea:
damn! thanks

 

[Kick]

am i right?

 

[janfred]

am i right?

of course you are.
The GND plate was isolated from the rest so I needed to insert some vias.
actually that was total obvious .. I failed this morning... :drevil:

 

[Kick]

u can use top/bottom layer to connect these 2 planes.I mean route using thick track(above 70mil).

 

[janfred]

Yes
I already did that after your first message.
Thanks Kick

 

[Kick]

ok..welcome