Eagle - Ripup but connected

Status
Not open for further replies.
J

janfred

Junior Member level 1
Joined
Jan 7, 2014
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
126
Hi guys,

i've a problem...
Eagle still shows me an airline(ripup-line) although it's connected by the GND-Layer and the Pads.



I did Ratsnest a couple of times, I tried a new GND-Polygon and I also checked the Schematics.. everything fine..

- How can I solve that?
- And by the way... are there options to increase the Isolation for the Ground-Pins?
 

Kick said:
am i right?
Click to expand...

of course you are.
The GND plate was isolated from the rest so I needed to insert some vias.
actually that was total obvious .. I failed this morning... :drevil:
 

u can use top/bottom layer to connect these 2 planes.I mean route using thick track(above 70mil).
 

Yes
I already did that after your first message.
Thanks Kick
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…