Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Eagle pro: How do you make it a 4 layer PCB?

Status
Not open for further replies.
T

treez

Guest
Hello, in Eagle pro, do yo uknow how to set the number of layers?

I see the bit in "DRC", and i think its [(1+2)(2+3)(3+4)] but im not sure.

I want blind vias from any layer to any layer. The three dielectric layers will be 0.6mm thick FR4
 
Last edited by a moderator:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top