Hi,
I would like to design a small double sided PCB, and I would like to make one of the side of the PCB like a male connector (that fits in a 12+12 slot).
I don't know the right terms in English, so I'll try to explain myself with a drawing:
Code:
+-------------+
| +---+_____==|
| | |_____==|
| |IC1|_____==|
| | |_____==|
| +---+_____==|
+-------------+
^^
This part of the PCB
will fit in a 4+4 slot (4 tracks on the top side of
the PCB 4 on the bottom side)
The right side of the PCB is "itself" a male connector.
I'm a newbie so I don't know how I can do it with Eagle (Light version).
I searched in frames and libraries, but didn't found such type of connector (it is not a true connector, as it is realized with the PCB).
Can you help me?
Thank you in advance and best regards,
Vor
Hi vorxio,
you are able to do that with the light version.
These are the limitations of Eagle light:
Maximum PCB-size 100 x 80 mm.
2 layer (Top und Bottom) verwendet werden.
Just one schematic-page.
You are not allowed to use the PCB for commercial purpose.
Of course not.
If you insist in a connector (with library) take the con-pc.lbr and look for the PCI_CON. It's a nacked PCI card. This will give you an idea, when you open it in the library editor how to make your own library.