blapcb
Full Member level 3
- Joined
- Jan 7, 2007
- Messages
- 188
- Helped
- 2
- Reputation
- 4
- Reaction score
- 0
- Trophy points
- 1,296
- Location
- Planet earth (most of the time)
- Activity points
- 2,766
Hi. I have searched the forum but could not come up with an answer for this. I have a mixed 5v and 3.3v circuit and am looking for an inexpensive (but good) chip to replace my power circuit (which at the moment is quite crude and has both a 5v regulator, 3.3 LDO and some electrolytic caps as well - too large a footprint and costly). Input range should be 10v to 30v or so (automotive). Looking for a low cost solution that will perform well, lower the footprint and not require any electrolytic caps. Any suggestions? Thanks.