Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

dsPIC33FJ128GP706 does not match expected ID

Status
Not open for further replies.

Pavel1986STula

Newbie level 6
Joined
Sep 21, 2010
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Russia, Tula
Activity points
1,403
Good time. I use Pickit3 (Firmware Suite Version...... 01.26.43+ MPlab 8.63) with dsPIC33FJ128GP706. But then I connect the cable, Mplab write: Target Device ID (00ad0000) does not match expected Device ID (00ed0000). I pay attention to the fact, that 00ad0000 is not equal to 00000000 (every time pic response same ID= 00ad0000 – and I except problem with board). It mean, that Pic is working. Maybe it is not dsPIC33FJ128GP706??? Can anybody ask, what pic have Device ID (00ed0000)??? Thank!
 

horace1

Advanced Member level 5
Joined
Nov 18, 2008
Messages
2,123
Helped
596
Reputation
1,188
Reaction score
573
Trophy points
1,393
Location
Norwich, UK
Activity points
13,069
if you look at chapter 7 of the dsPIC33F/PIC24H Flash Programming Specification
https://ww1.microchip.com/downloads/en/DeviceDoc/70152c.pdf

the dsPIC33FJ128GP706 has ID 0xED
the is no device in the list with ID 0xAD

I assume you have checked the number on the chip?
either you have another device or something is wrong with the hardware - check the supply voltages, connections, etc
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top