I have been using IT TMS30F28335 DSP to for different system controllers . All designed hardware was working good so far. Now, it is to develop a new hardware for different purpose. But , it prompts error when connecting Emulator/debugger/ for which a screenshot is attached herewith. For all hardware we designed so far, we used digital and analog ground for the DSP power supply connections and other electrical components as it is recommended in TMS32028x Design guideline. But , for the recent one, our hardware Engineer changes all to analog ground . could this be a reason for the error? is that mandator to use both analog and digital ground while designing TMS320F28335?
There are hundred reasons why the debugger can't connect, e.g. missing power supply, device hold in reset, netlist error. Analog and digital ground connection is more a question of optimizing analog noise rejection. Shouldn't affect the digital section as long as all required ground connections are actually present.
Start the basic work, check supply voltages, clock oscillator is operating, debug interface wired correctly etc.
There are hundred reasons why the debugger can't connect, e.g. missing power supply, device hold in reset, netlist error. Analog and digital ground connection is more a question of optimizing analog noise rejection. Shouldn't affect the digital section as long as all required ground connections are actually present.
Start the basic work, check supply voltages, clock oscillator is operating, debug interface wired correctly etc.
FvM, thank you a lot for your support.
I have checked a supply voltage at each checking points. All are as they are supposed to. A debug interface is also exactly the same with what I have been using for other properly working hardware. But, the DSP external Oscillator is not oscillating the correct frequency. I guess this is because the DSP is not working properly. what do you think about it?