Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Does anyone know the difference between E8 and E8a renesas

Status
Not open for further replies.

xxtigerxx

Advanced Member level 1
Joined
Jun 5, 2001
Messages
444
Helped
38
Reputation
76
Reaction score
32
Trophy points
1,308
Location
Greece
Activity points
2,903
E8 and E8a is a on chip debug emaluator.

Does anyone know the difference between E8 and E8a renesas?

:p
 

wpom

Newbie level 5
Joined
Jun 27, 2001
Messages
10
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Location
Nonthaburi, Thailand
Activity points
45
Re: Does anyone know the difference between E8 and E8a renes

The E8a on-chip debugging emulator is a development of the E8, maintaining the same functionality and ease of use whilst reducing both cost to the end user and the size of the unit.


What's improved?


- New microcomputers for on-chip debugger are supported. (M16C/65 Group etc.)
- About 60 percent smaller in volume and its plastic case is made from a biodegradable material. (a vegetable-based polylactide [PLA])
- Adopted a general connector as a user interface cable.

- All Families of flash microcomputers are supported for programming. (As the supported microcomputers will be added progressively, please refer to the following list.)

Please see this link

http://www.renesas.com/fmwk.jsp?cnt...ools/emulation_debugging/onchip_debuggers/e8a
 

    xxtigerxx

    points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top