butlermatrix
Junior Member level 2
Hi,
I am using ADS 2016 and to reduce the time taken for each simulation I have reduced the Mesh Density (cell/wavelength) to 5 and the solver compression level to "Reduced". Do these changes anyhow distort the radiation pattern I get as an outcome of my experiment?
I can observe from the figure below that I have grating lobes and to reduce them I need to lower or equal the inter element spacing to λ/2 mm. I am working with an inter-element spacing of 1.9 mm.
Is the problem below a problem with my design and concept or some issue with the software which I am not understanding?
I am attaching the file below.
Any sort of help will be much appreciated.
I am using ADS 2016 and to reduce the time taken for each simulation I have reduced the Mesh Density (cell/wavelength) to 5 and the solver compression level to "Reduced". Do these changes anyhow distort the radiation pattern I get as an outcome of my experiment?
I can observe from the figure below that I have grating lobes and to reduce them I need to lower or equal the inter element spacing to λ/2 mm. I am working with an inter-element spacing of 1.9 mm.
Is the problem below a problem with my design and concept or some issue with the software which I am not understanding?
I am attaching the file below.
Any sort of help will be much appreciated.