Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Discrete frequency to voltage converter?

Status
Not open for further replies.
Can you help me design a more sharp (the sharpest the better) tuneable RC HPF fot HF?

Cheers

Another thing to try, is to take advantage of the steep curve of a high Q resonant filter. You can tap to the right or the left of the center frequency.

You would need to adjust the LC frequency so it is a few MHz distant from whatever is your desired frequency.

Another concept. You can make the curve steeper by amplifying the output. For instance, via a transistor amplifier.

Another concept. Put a diode inline, and you subtract 0.6V. Then by amplifying this, you obtain a steeper curve.
 
  • Like
Reactions: neazoi

    neazoi

    Points: 2
    Helpful Answer Positive Rating
Another concept. You can make the curve steeper by amplifying the output. For instance, via a transistor amplifier.

Another concept. Put a diode inline, and you subtract 0.6V. Then by amplifying this, you obtain a steeper curve.

I would be interested in more information or examples on these please
 

a good frequency to voltage converter is to make a PLL, and lock the VCO to your incoming signal. If you measure the VCO tune voltage when the PLL is locked, it is proportional to the incoming frequency.

if it is narrowband tuning range, you can just do a delay line frequency discriminator, or an Armstrong discriminator
 
  • Like
Reactions: neazoi

    neazoi

    Points: 2
    Helpful Answer Positive Rating
I would be interested in more information or examples on these please

You can run the output into an amplifier, as below. It does not need to be a high-frequency device.

To create a steeper curve, my simulation has an op amp, with a reference voltage at one input. A pot provides variable gain.



If you want simple discrete components then a transistor ought to be able to do a similar job.

Stable voltage regulation is needed in order to make this method work.

You can obtain several volts range from this. Naturally, resolution is less precise when you want to represent a wide frequency range.
 
  • Like
Reactions: neazoi

    neazoi

    Points: 2
    Helpful Answer Positive Rating
You can run the output into an amplifier, as below. It does not need to be a high-frequency device.

To create a steeper curve, my simulation has an op amp, with a reference voltage at one input. A pot provides variable gain.



If you want simple discrete components then a transistor ought to be able to do a similar job.

Stable voltage regulation is needed in order to make this method work.

You can obtain several volts range from this. Naturally, resolution is less precise when you want to represent a wide frequency range.

Have you attached a schematic? I cannot see it.

- - - Updated - - -

if it is narrowband tuning range, you can just do a delay line frequency discriminator, or an Armstrong discriminator

Can you display examples of these circuits? I would be interested to know as well.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top