junsik
Junior Member level 2
Hi everyone. I am trying to simulate coupling problem using CST microwave studio.
I have some meshing problem. I know that increasing 'lower mesh limit' is helpful for the accuracy of the simulation. However, when I increase the 'Lower mesh limit' the coupling is decreased as much more than that I expect.
So, I want to know what is good meshing setup. How to determine the proper 'Lower mesh limit' ?
I have some meshing problem. I know that increasing 'lower mesh limit' is helpful for the accuracy of the simulation. However, when I increase the 'Lower mesh limit' the coupling is decreased as much more than that I expect.
So, I want to know what is good meshing setup. How to determine the proper 'Lower mesh limit' ?