Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Differences between MWO and IE3D simulation

Status
Not open for further replies.

Javirulo

Newbie level 6
Joined
Oct 20, 2005
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Spain
Activity points
1,399
Hi everybody :

I've designed four prototipes of printed antennas for wireless comunication using Microwave Office and then I've export the designs to IE3D Zeland in order to compare the results, but they were totally different. Then I've built the antennas and the experimentals results are more accurate to the ones using IE3D. Where could be the problem? Maybe any mistake using Microwave or something like that.
Any help will be very useful. Thanks
 

nikhilele

Advanced Member level 3
Joined
Jan 11, 2006
Messages
805
Helped
101
Reputation
202
Reaction score
76
Trophy points
1,308
Location
Bangalore India
Activity points
6,375
first tell which type of simulation u have done using microwave office, if u have done ckt simulation then u will get different results, especially for antennas u should go for full wave 3d em simulation.
 

Manjunatha_hv

Advanced Member level 3
Joined
Aug 3, 2005
Messages
810
Helped
240
Reputation
480
Reaction score
122
Trophy points
1,323
Location
INDIA
Activity points
8,689
Attach/upload your MWO project files (*.emp)...So that I help you what may be the best setup to analyse antennas in Shielded MoM EM simulator....

For your information IE3D is an Unshileded MoM EM Simulator and it is good for Antenna analysis (Radiation applications)...


---manju---
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top