Non AMP

Difference in design in low power matched load and high power matched load?

Thread starter suhasd90
Start date May 25, 2018

Status: Not open for further replies.

May 25, 2018

#1

S

suhasd90

Newbie level 6

Low power = 10 mW and lesser.

High power = 1 W and higher.

Status: Not open for further replies.

Similar threads

R
What is the difference between power probe P_Probe1.p and P_Probe1.deltav in ADS?
- Started by RFan
- Dec 26, 2023
- Replies: 5
RF, Microwave, Antennas and Optics
S
Finding the combined output power of power amplifier in ADS
- Started by sit_ec_2024
- Mar 2, 2024
- Replies: 6
RF, Microwave, Antennas and Optics
N
How to design input and output matching ckt of PA for getting desired o/p Power and PAE
- Started by narayani
- Mar 20, 2024
- Replies: 3
RF, Microwave, Antennas and Optics
R
How to perform load pull and source pull for Continuous class F power amplifier(PA) Design?
- Started by rd_dinesh
- May 21, 2023
- Replies: 0
RF, Microwave, Antennas and Optics
P
Clarification regarding calculating input power of Power Amplifier
- Started by pusparaga
- Feb 12, 2024
- Replies: 3
RF, Microwave, Antennas and Optics